|
FLT-01
Bike 12V power filter |
|
Introduction
The power
filter unit is designed to reduce/remove conducted electrical interference
noise from the power supply. This applies to electrical noise generated by
the bike ignition, alternator and pumps, (this noise will only be present
when the bike engine is running).
Applications
1) Universal power filter, suitable for use with most bike
power accessories e.g. Bike radios, CBs,
Audio systems, Navigation systems, cell/Mobile phones, etc..
2) StarCom1 / Advance power filter (plugs directly into StarCom1).
3) StarCom1 accessory power filter.
Specification
Max current: 3 AMPS
Max Volts: 15 Volts
Dimensions: 1¼" x ¾" x 1¾"
Inline fuse: 3A slow blow
|
|
Unit
Installation
Installation with a StarCom1 system
Step 1.
Locate a suitable point for power connection.
Step 2.
Using a crimp connector (Crimp1) or solder joint, connect the fused power
filter INPUT lead +ve which is the RED wire to a bike 12V supply.
Step 3.
Using a crimp connector (Crimp2) or solder joint, connect the power lead
-ve, which is the BLACK wire, to the bike 0V (negative) supply or to a
suitable chassis ground point. Tape all joints to insulate electrically
and protect from moisture.
Step 4.
Connect the StarCom1
Step 5.
Using the 10cm cable ties provided ensure that the fuse crimp connectors and
the wiring are secured to the bike frame along the full cable at least every
15cm. You must ensure that the wire cannot fall or bend and foul or touch
any moving parts. You must also ensure the wire will not be trapped or
pinched in any way, for example by the seat. Only mount to the bike frame or
bodywork and avoid all working parts including brake pipes, ignition cables,
etc.
|
|
 |
| |
| |
|
Installing with a StarCom1 system and a StarCom1 Accessory
Installation with a StarCom1 system and a StarCom1
Accessory
Power for an accessory can be
taken from the StarCom power lead.
Step 1.
Carefully separate the two wire close to the StarCom power plug providing
2cm wire length to allow crimp connection.
Step 2.
Using a crimp connector (Crimp 3), connect the RED wire to the accessory
+12V (positive) supply wire.
Step 3.
Using a crimp connector (Crimp4), connect the Black wire to the accessory
0V ground (negative) wire.
Step 4.
Using the 10cm cable ties provided ensure that the crimp connectors and the
wiring is secured to the bike frame along the full cable at least every
15cm. You must ensure that the wire cannot fall or bend and foul or touch
any moving parts. You must also ensure the wire will not be trapped or
pinched in any way, for example by the seat. Only mount to the bike frame or
bodywork and avoid all working parts including brake pipes, ignition cables,
etc.
|
 |
Important fitting considerations
1)
DO NOT REVERSE CONNECT, The RED wire must be connected to
12V and the BLACK to 0V reverse connection will cause permanent
damage to the filter.
2)
Ensure all wires are as short as possible.
3)
Do not locate the power filter, the StarCom1 unit or the
accessory close to the bike ignition system.
4)
FLT-01 must only be used on a 12V DC system.
5)
Maximum current is 3 Amps, note StarCom1 consumes a maximum
of 0.25 Amps.
Fitting Kit
10x short tie
wraps 4x scotch lock splice 1x loop Velcro 1x hoop Velcro
|
|
